Elba N55 204 Série Mode D'emploi page 14

IGNITION OF THE OVEN BURNER
Models with gas tap
ATTENTION: Never turn the gas tap
before approaching a flame to the hole
"A" of the floor.
WARNING: Risk of explosion! The
oven door must be open during this
operation.
To ignite the burner:
1. Open the oven door to the full extent.
2. Approach a flame to the burner. You
must be careful to approach the flame
to the hole "A" (fig. 4.3) before turning
the tap on (fig. 4.4), never viceversa.
3. Press the knob thoroughly and turn it
anti-clockwise of 90° (fig. 4.4).
4. Adjust the burner according to the po-
wer required.
To turn it off, turn the knob towards the
right, up to the safety click.
A
14
Models with gas thermostat
ATTENTION: Never turn the gas ther-
mostat before approaching a flame to
the hole "A" of the floor.
WARNING: Risk of explosion! The
oven door must be open during this
operation.
To ignite the oven burner:
1. Open the oven door to the full extent.
2. Approach a flame to hole "A" (fig.
4.3).
3. Press thoroughly the knob and turn
it anti-clockwise; the indicator should
match with the number 10.
Only for the models N55 .. 220, N55


.. 222, N55 .. 320, N55 .. 322: Keep
the knob pressed.

Never continue this operation for
more than 15 seconds. If the burner
has still not ignited, wait for about
1 minute prior to repeating the igni-
tion.
4. Only for the models N55 .. 220, N55
.. 222, N55 .. 320, N55 .. 322: After
lighting the burner, wait a few seconds
before releasing the knob (until the sa-
fety valve stays open).
5. Gently close the oven door and set the
oven control knob to the required tem-
perature.
Fig. 4.3 Fig. 4.4