Bosch Intuvia 100 Manuel Du Propriétaire page 11

Inserting and Removing the On-Board
Computer
(10)
(9)
(8)
(7)
To insert the (9) on-board computer, insert the lugs
of the battery compartment (10) into the cradle (8)
of the holder, and gently press down on the on-board
computer. To lock, turn the on-board computer clock-
wise until it engages.
To remove the on-board computer (9), turn it coun-
terclockwise and remove the on-board computer
from the cradle (8).
When you park up the eBike, remove the on-
u
board computer.
Inserting the Locking Screw
(3)
The on-board computer can be secured in place to
prevent it from being removed from the holder. The
on-board computer must be in the holder for this.
Bosch eBike Systems
Assembly
Undo the fastening screw (11) of the clamp with a
hex key until the holder (7) can be moved. Turn the
holder (7) until the bottom side of the on-board com-
puter is accessible. Insert the locking screw (6) and
bolt it with the on-board computer. Align the
holder (7) correctly with the on-board computer and
(9)
tighten the fastening screw (11) again with a hex key.
Note: The locking screw is not designed to prevent
theft.
(6)
(11)
(8)
English – 9
0 275 U07 3BI | (03.03.2023)