EDM Product 33821 Manuel D'instructions page 20

PRE-INSTALACIÓN
ES
PT
Note: fittings are not shown in actual size.
EN
Blade fixing screw and fibre washer
Self-tapping screws
Expansion bolts
Balanced parts package
FR
MOUNTING SUSPENSION
For wooden ceilings, use wood screws to drill the wooden beam or
the "junction box" to fix the hanging bracket (the selection is made
according to the actual requirements of the customers).
WOODEN CEILING
WOODEN CEILING
Cut the light from the light inlet box at home, the fuse box.
1) Using the mounting bracket (A) as a guide, mark the points
where the 4 self-tapping screws (B) are to be drilled.
2) Remove the mounting bracket (A), drill 4 holes of 3 mm
diameter and install the mounting bracket on the wooden
ceiling with the 4 self-tapping screws (B).
IMPORTANT: The screws must be tightened until snug.
Instruction manual
For the concrete ceiling, use the hammer drill bit with a diameter of
8 mm to drill holes according to the length of the expansion screws.
Then use the enclosed expansion screws to fix the hanging bracket to
the ceiling (the selection is made according to the actual requirements
of the customers)..
CONCRETE CEILING
Cut the light from the light inlet box at home, the fuse box..
1) Using the mounting bracket (A) as a guide, mark the points
where the 2 expansion bolts (B) are to be drilled.
2) Remove the mounting bracket (A). Drill 2 holes of 8 mm
diameter and insert 2 expansion bolts (B) into the concrete
ceiling, install the mounting bracket and secure with flat
washers (C), spring washers (D) and nuts (E).
Mounting
IMPORTANT: Bolts must be tightened until snug..
Bracket (A)
Self-tapping
screws (B)
CONCRETE CEILING
expansion bolts (B)
Flat Washers (C)
Spring washers (D)
Nuts (E)
Ref. 33821
Bracket
mounting (A)