Worx WG540 Mode D'emploi page 10

ASSeMBLY
ASSEmBLiNG tHE BLOwER tuBE
(Fig A1 & Fig A2)
Before assembling the Blower Tube(4), be sure
the on/off switch (2) is in ''O'' Off position.
Fit the Blower Tube to the motor housing as
shown in Fig A1. Check the Blower Tube is
firmly secured.
wARNiNG! Do not attempt to operate
or disable the On/Off Switch by any
means other than the normal assembly or
removal of the tube.
NOtE: Before disassembling the Blower
Tube, be sure the on/off switch (2) is in ''O'' Off
position. Press the Release Button(3) , so that
you can separate the tube.(Fig A2)Do not try to
separate the tubes by force or by using tools.
OPeRATIOn
wARNiNG! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
10 10
occur.
1. BEFORE uSiNG yOuR CORDLESS
BLOwER
Your battery pack is UNCHARGED and you
must charge once before use.
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
2. CHARGiNG yOuR BAttERy PACk
The Li-ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
18V Cordless Li-ion Blower/Sweeper
All manuals and user guides at all-guides.com
3. iNStALL tHE CHARGER-wA3838
StANDS(wG540.5)(See B)
Slide the two charger stands (a) into the both
grooves on back of the charger. The charger
can stand as shown in Fig.B.
4. HOw tO CHARGE yOuR BAttERy(See
C1/C2)(wG540/wG540.5)
Connect the battery charger (6/7) to the
power supply and the green light (6b/7b) will
illuminate.
Slide the battery pack into the charger to make
the connections (See C1/C2 ).
The green light(6b/7b) will be off. And the red
light(6a/7a) will illuminate to show charging
has started. When charging is completed the
green light(6b/7b) will illuminate while the red
light(6a/7a) is off.
NOtE:
This charger is designed to detect some
problems that can arise with battery pack. (see
table below)
en