Panasonic S-36PT1E5 Instructions D'installation page 5

1. GENERAL
This booklet briefly outlines where and how to install the
air conditioning system. Please read over the entire set of
instructions for the indoor and outdoor units and make sure all
accessory parts listed are with the system before beginning.
1-1. Tools Required for Installation (not supplied)
1. Flathead screwdriver
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Carpenter's level
6. Sabre saw or key hole saw
7. Hack saw
8. Core bits
9. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for deburring)
1-2. Accessories Supplied with Unit
See Table 1-1.
Table
1-1 Ceiling
1-3. Type of Copper Tube and Insulation Material
If you wish to purchase these materials separately from a local
source, you will need:
1. Deoxidized annealed copper tube for refrigerant tubing.
2. Foamed polyethylene insulation for copper tubes as
required to precise length of tubing. Wall thickness of the
insulation should be not less than 8 mm.
3. Use insulated copper wire for field wiring. Wire size varies
with the total length of wiring. Refer to 4. ELECTRICAL
WIRING for details.
CAUTION
Check local electrical codes and regulations before
obtaining wire. Also, check any specified instructions or
limitations.
1-4. Additional Materials Required for Installation
1. Refrigeration (armored) tape
2. Insulated staples or clamps for connecting wire (See your
local codes.)
3. Putty
4. Refrigeration tubing lubricant
5. Clamps or saddles to secure refrigerant tubing
6. Scale for weighing
PAC-i̲T1-type.indb 5 PAC-i̲T1-type.indb 5
All manuals and user guides at all-guides.com
Type
5
Table 1-1 (Ceiling)
Part Name Figure Q'ty
Special
4
washer
T10
Drain
1
insulator
T5 T3
2
Flare insulator
sets
Insulating
2
White
tape
(heat-
resisting)
Vinyl clamp 8
Eyelet 1
Full-scale
installation 1
diagram
Drain hose 1
L140
Hose band 2
Remarks
For temporarily
suspending indoor unit
from ceiling
For drain hose joint
For gas and liquid tube
joints
For gas and liquid flare
joints
For flare and drain
insulator (Field supply
for Spanish version)
For power supply inlet
Printed on container box
For main unit + PVC
pipe joints
For drain hose
connection
2012/01/19 10:09:27 2012/01/19 10:09:27