Fitting The Unit Head - Oase Vitronic 9W Notice D'emploi

- English -
Maintenance and cleaning (cont.)
● Do not use aggressive cleaning agents or chemical
solutions as they could attack the housing or impair the
functionof the unit.
● Recommended cleaning agent for removing stubborn
limescale deposits: Vinegar and chlorine-free household
cleaning agent.
● After cleaning, thoroughly rinse all parts in clean water.
Removing the unit head
1. Disconnect the pump from the power source.
○ Disconnect the tubing.
Vitronic 9W
2. Turn the unit head counter-clockwise up to the stop and
carefully pull it out of the casing together with the O ring.
○ Thoroughly clean the inner and outer surfaces of the
casing.
Vitronic 18W / 36W
2. Press the engagement hooks.
3. Turn the unit head counter-clockwise as far as the stop
and carefully pull it out of the casing.
○ Thoroughly clean the inner and outer surfaces of the
casing.
Note!
For safety reasons the UVC lamp can only be switched on when the unit head
has been correctly fitted into the casing.

Fitting the unit head

1. Check the O ring at the unit head for correct seating.
○ Clean the O ring, replace if damaged.
2. Carefully push the unit head into the casing up to the
stop while applying slight pressure.
○ Turn the unit head slightly so that the tenons and
grooves of the bayonet closure intermesh.
3. Turn the unit head clockwise up to the stop.
○ For Vitronic 9W only the two arrows on the casing
and unit head must point towards one another.
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
2.
Vitronic 9W
Vitronic 18W / 36W
Vitronic 9W
Vitronic 18W / 36W
2.
3.
7