PULOX PO-300 Mode D'emploi page 93

Appendix
Appendix 1
State
Low voltage
alarm
SpO2 alarm
Pulse rate alarm
Probe error
alarm
Appendix 2
Guidance and manufacture's declaration – electromagnetic emissions-
Guidance and manufacture's declaration – electromagnetic emission
The CMS50E Pulse Oximeter is intended for use in the electromagnetic
environment specified below. The customer of the user of the CMS50E Pulse
Oximeter should assure that it is used in such and environment.
Emission Compliance
test
RF
emissions
CISPR 11 Group 1
RF
emission
CISPR 11
Class B
Guidance and manufacture's declaration – electromagnetic immunity –
Guidance and manufacture's declaration – electromagnetic immunity
The CMS50E Pulse Oximeter is intended for use in the electromagnetic
environment specified below. The customer or the user of CMS50E Pulse
Oximeter should assure that it is used in such an environment.
Alarm condition
delay
60 s
1 s
1 s
16 ms
Guidance and manufacture's declaration
for all EQUIPMENT and SYSTEMS
Electromagnetic environment – guidance
The CMS50E Pulse Oximeter uses RF energy
only for its internal function. Therefore, its
RF emissions are very low and are not likely
to cause any interference in nearby
electronic equipment.
The CMS50E Pulse Oximeter is suitable for
use in all establishments, including
domestic establishments and those directly
connected to the public low-voltage power
supply network that supplies buildings used
for domestic purposes.
for all EQUIPMENT and SYSTEMS
Alarm signal generation
delay
5 ms
5 ms
5 ms
5 ms