PULOX PO-300 Mode D'emploi page 22

Oxymètre de pouls
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Testee's fingernail can not be too long.
Please refer to the correlative literature about the clinical restrictions
and caution.
This device is not intended for diagnosis.
The User Manual is published by our company. All rights reserved.
1. Safety
1.1 Instructions for Safe Operations
 Check the main unit and all accessories periodically to make sure that
there is no visible damage that may affect patient's safety and
monitoring performance about cables and transducers. It is
recommended that the device should be inspected once a week at least.
In case of obvious damage, stop using the device.
 Necessary maintenance must be performed by qualified service
engineers ONLY. Users are not permitted to maintain it by themselves.
 The oximeter cannot be used together with devices not specified in
User's Manual. Only accessory appointed or recommended by
manufacture can be used with this device.
 This product is calibrated before leaving factory.
1.2 Warning
Explosive hazard—DO NOT use the oximeter in environment with
inflammable gas such as some ignitable anesthetic agents.
DO NOT use the oximeter while the testee measured is being measured
by MRI and CT.
Be careful with the use of the lanyard cord. Improper use of the lanyard
cord will cause device damage not covered under the manufacturer's
warranty. Swinging the device by the lanyard cord will void the warranty.
Please do not use lanyard cord if allergic to lanyard cord.
The disposal of scrap instrument and its accessories and packings
(including battery, plastic bags, foams and paper boxes) should follow
the local laws and regulations.
Please check the packing before use to make sure the device and
accessories are totally in accordance with the packing list, or else the
device may have the possibility of working abnormally.
Please choose the accessories and probe which are approved or
manufactured by the manufacturer, or else it may damage the device.
Please choose the battery chargers which should be ensured compliance
with the requirements of IEC 60601-1, or else it may damage the device.
Please don't use the device in the course of charging.
EN

Publicité

Table des Matières
loading

Table des Matières