PULOX PO-300 Mode D'emploi page 30

EN
The values displayed in Figure 8 are the initial values of over-limit prompt.
After setting, short press the button to select "Exit", then long press the
button to exit sound setting interface, and return to Main Menu interface.
B. Data storage
Under the main menu, short press the button to select "Record", then long
press the button to enter the Record Menu interface as shown in Figure 7. It
indicates that the device is storing when the red dot "R●" in measurement
interface flickers.
Short press the button to select the option to be adjusted, then long press
the button to change the value.
"Mode": record mode selection, including: "Auto" and "Manual" mode.
Under "Manual" mode, select to turn on / off memory by "Record".
Auto record: start recording after stable data appear, pull out the finger to
finish recording a group of data (99 group of data at most), the total
duration does not exceed 72 hours.
Manual record: store up to 24-hour data.
When the memory is full, it will display "Memory is full!", then it will enter
the standby mode after several seconds. When exiting the standby mode, it
will display "Memory is full!" to give user a prompt, press the button again
to enter the measurement interface.
Note: under manual mode, when "Record" is "ON", the device will prompt
to clear the data stored last time.
It will display "Recording" when there is no operation under record state for
30s, then it will enter energy saving mode after several seconds, long press
the button to exit this mode; short press the button, it will display
"Recording".
Note: under data recording state, after the display screen turns off
automatically, in order to save power, pulse sound indication will turn off
automatically.
"Seg": data segment.
After setting, short press the button to select "Exit", long press the button to
exit record menu and return to main menu.
"Delete All": delete all records (auto record mode is shown as Figure 9).
Note: please upload data in time after recording, otherwise the data may be
covered when the storage space is full.
Note: the historical data will be deleted once switching the mode. Under
recording state, the record mode can not be switched; under manual mode,
the record mode can be switched only when turning off recording firstly.
C. Time setting
a. Connect the master device to synchronize device time