LUCCI Air ATLANTA Manuel D'installation page 9

72'' ATLANTA Installation Instructions
REMOTE CONTROL (Fig.16)
1. Open the battery compartment cover by removing the securing screw and insert 2 x AAA battery. Note the
correct battery polarity (+/-) when inserting the battery, and then replace the cover and secure with the
screw.
2. Test the remote by pressing and hold any button. A blue LED will be lit up at the top of the remote to
indicate that there is power to the remote and it is ready for use to control the fan.
3. Follow the guide below to operate the fan and learn the functions.
Fig. 16
The LED light has a 3-step dimmable function which is controlled by an ON/OFF switch.
When the LED light is ON and at 100% brightness, press the light button "ON and then OFF within 5
seconds", to dim the LED light. Repeat pressing ON and then OFF within 5 seconds to dim further in the
following sequence: 100% brightness → 50% brightness → 20% brightness → 100% brightness.
To switch back to 100% brightness at any stage, turn OFF the luminaire, and then wait after 5 seconds turn
ON the luminaire, it will reset to 100% brightness.
The remote has memory function. If the fan is turned off by the isolating switch over 5 seconds, the next time
to turn on the fan will be on last setting.
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
NOTE: The pairing of the remote and receiver has been done at the factory.
When the ceiling fan is installed, pairing the fan receiver and remote is NOT required.
NOTE: the fan is DC fan, there is some "stutter" for the fan during pairing ，or
fan would some "stutter"
8 | P a g e
USING YOUR CEILING FAN
before starting the rotation. this is
at either rotation direction, the
normal.