LUCCI Air ATLANTA Manuel D'installation page 5

72'' ATLANTA Installation Instructions
INSTALLATION OF BLADE (Fig. 8)
1. Before Installing the blades, remove the motor blade screws from the bottom of the fan motor assembly.
2. Insert the blade into the slot of rotating member of fan motor assembly.
3. Align and engage the holes of the blade to the blade bracket.
4. Secure the blade to the fan motor assembly by tightening the 3 blade screws.
Ensure all screws are tightened evenly to reduce the chance of warping or unbalancing.
Take care not to over tighten the screws, as this can damage the blades.
Take note the correct side of the blades with the marking "THIS SIDE UP" faces the ceiling.
5. Repeat the same process for the other blades.
NOTE: Don't run the motor without blades installed!
INSTALLATION OF LIGHT KIT (Fig. 9)
• Align the two slot screws of the motor part with the keyhole slots of the light kit bracket (3).
• Turn the light kit bracket anticlockwise until the slot screws are firmly at the end of the slots.
Tighten the screw (2) and the 2 slot screws to secure the light kit bracket. Fig.9a
Install the lamp (4) to the GX53 lamp holder (5). Do not exceed the maximum power rating. Fig.9b
4 | P a g e
INSTALLATION OF THE FAN
Fig. 9a
Fig. 8