Publicité
Les langues disponibles
Les langues disponibles
No.
Item name
45
Hexagon socket head screw M8x12
46
Hexagon socket pan head half-thread screw M8x30
47
Hexagon socket pan head screw M8x35
48
Hexagon socket pan head screw M8x16
49
USB
50
Hexagon socket countersunk head screw M8x35
51
Hexagon socket countersunk head screw M8x20
52
Cross recessed pan head tapping screw 4.2x16
53
Hexagon lock nut M8
54
M8 gasket
55
Communication line
56
Upper section of communication line
57
Lower section of communication line
58
Cross recessed pan head tapping screw 2.9x6.5
Cross recessed countersunk head tapping
59
screw 4.2x30
Cross recessed pan head tapping and self-drilling
60
screws 4.2x16
61
Cross recessed pan head tapping screw 4.2x22
Cross recessed flange head tapping screw 2.6x9
62
Cross recessed countersunk head tapping and
63
self-drilling screws
EVA adhesive tape
64
Button sticker
65
14
3. Installation Steps
Qty
2
2
2
2
1
2
6
21
2
6
2
1
1
16
1. Take the main machine out of the carton box and lay it flat on the
carpet or soft cushion. Step①: put the main machine on its side,
14
screw the four foot pads clockwise into the screw holes on the back
sides, and then lay it flat. Step②⑤: lift the riser up, and turn the
21
computer display to the position shown in the figure (don't press the
2
communication line when the computer display component is put
down, to prevent damage to the lines when installing screws). Step
10
③④: use the "6MM Allen key" to lock the left and right risers to the
frame. Step⑥: use "M8*16 hexagon socket pan head screws" and
6
M8 washers to lock the computer display on the left and right risers.
1
Step⑦: after confirming that the riser is locked, fasten the lower
cover of the riser on the left and right risers respectively.
1
15
Publicité
