Costway SP37619CA Mode D'emploi page 13

7. Product maintenance
1. Lubrication
When the running machine is used for a period of time, it must be
lubricated with special methyl silicone oil.
Advice:
★ 1 hour or less per week
★ Less than 3 hours per week
3-6 hours per week
★
More than 6 hours per week lubricate once a month. Do not
lubricate too much. It is not the more lubricants the better.
Remember: Proper lubrication is an important factor in improving
the life of the treadmill.
2. As for the way to check if you need to add lubricant.
Just grab the running belt and touch the middle of the
running belt back with your hands as much as possible.You
don't need to add lubricant if you have silicone on your hand
(a little damp). You have to add lubricant if the pad is dry
and there is no silicone on your hand.
★Steps to add lubricant to the running plate (as shown in the right
picture)
★Stop running and fold the machine.
★Lift the running belt of the underside of the main body. Put the
oil pot as far as possible into the middle of the running belt. And
spray methyl silicone oil inside of the running belt and both sides.
★You can make use of the treadmill speed of 1km/h to evenly
lubricate and step on the running belt from left to right. After a few
minutes, the methyl silicone oil can be completely absorbed by the
running belt.
24
lubricate once every 6 months
lubricate once every 3 months
lubricate once every 2 months
3. Adjust tightness of running belt
All treadmills shall be adjusted for tightness before delivery and
after installation. However, the running belt may be loosened after a
period of use. For example,the treadmill has problems with stopping
and slipping during exercise. Adjust bolts of running belt with the
left and right synchronous as per clockwise direction to half a circle
as the unit when this phenomenon occurs. The feet will slip if the
running belt is too loose. But it is not good to be too tight. It is easy
to increase the load of the motor and damage the motor, running
belt and roller etc.
4. Running belt deviation adjustment
All treadmills need to adjust the running belt before delivery and
after installation. But the running belt may be deviated after a
period of use which may be caused by the following reasons:
① The main body is not placed smoothly.
② The feet of users are not in the center of the running belt.
③ Uneven force on the user's feet.
It will be returned to normal after a few minutes of no-load
rotation if deviation is caused by man-made. It should be
adjusted with 6mm wrench at a half circle as the unit for
deviation of non-recover automatically.
Please adjust left bolt with
clockwise or right bolt with
counterclockwise if running
belt deviates to the left.
The running belt deviation is mainly maintained by the user according
to the manual. Running belt deviation will seriously damage the
running belt.This point must be found in time and corrected at once.
Please adjust right bolt with
clockwise or left bolt with
counterclockwise if running
belt deviates to the right.
25