Télécharger Imprimer la page

TXED BIKE 4000RM LS Mode D'emploi Et D'entretien page 37

Vélo à assistance électrique 26”

Publicité

Les langues disponibles
  • FR

Les langues disponibles

From the initial position 12 o'clock (where the battery and carrier are unlocked), insert the key into the key
slot, press and turn it clockwise to position 6 o'clock (Then the battery is locked with the carrier). On the
contrary, you can unlock it.
Battery charge
If an AC outlet is available within reach of your bike, you can charge your bike directly with the battery still
attached to the bike. The charging port is covered by a plastic cap, with a yellow arrow for notice (Fig 4.3).
Pls open it then you charge the battery directly (Fig 4.4).
Removing the battery is useful for charging in a location where the bicycle may not fit or when no reachable
AC power supply exists at the place where the bike is parked.
Before removing the battery from the bike, you need to unlock as following steps:
* make sure the switch is off (Fig4.5).
* Press the key and turn it anticlockwise from 6 o'clock to 12 o'clock position. (ref. Fig 4.2)
* Remember to take off and care about the key after you withdraw the battery from the carrier!!!
(Fig. 4.3)
(Fig. 4.4)
(Fig. 4.5)
5.
LED and Function
5.1 6KM/H (Fig. 5)
Long press the "+" button to use the "assisted start" function to facilitate
the start of the race.
After the motor starts working and the bike running, you could easily
pedal and release the button.
(Fig. 5)
37/72

Publicité

loading