Télécharger Imprimer la page

Star Ultra Max UM1850A Instructions D'installation Et De Fonctionnement page 9

Publicité

Unless specified otherwise, conveyor travel is factory set for left to right operation when facing the
front of the oven. If a direction change is required, refer to "DISPLAY INFORMATION," section 3 for
instructions on how to program the controller for a direction change. In addition, the conveyor belt
must be changed to travel in the new direction.
SAFETY OPERATING INSTRUCTIONS
The information contained in this section is provided for the use of qualified operating personnel.
Qualified operating personnel are those who have carefully read the information contained in this
manual, are familiar with the functions of the oven and/or have had previous experience with the
operation of the equipment described. Adherence to the procedures recommended herein will assure
the achievement of optimum performance and long, trouble-free service.
STACKING INSTRUCTIONS
The following instructions should be followed when stacking
more than one unit.
Single Oven (or Bottom) Cart Install:
1. Remove door, conveyor, and finger assemblies.
2. Unbolt unit from shipping crate (2 bolts).
3. Turn unit on front as shown.
4. Thread the four legs into the bottom of the oven.
5. CAREFULLY lift oven upright.
Stacked Oven Install Preparation:
1. Remove door, conveyor, and finger assemblies.
2. Unbolt unit from shipping crate (2 bolts).
3. Turn unit on front as shown.
4. Remove top of lower oven (4 screws total, 2 each front and rear)
and bolt to stacked oven base using 3/8 - 16 bolts.
5. Place top oven on lower unit and re-attach with screws for top of
lower oven.
OPERATING INSTRUCTIONS
DO NOT ATTEMPT TO OPERATE THE OVEN until connection of
utility service and installation has been fully inspected (start-up check-
out) by an authorized service technician or a Star Service Technician
in order to assure the oven is properly installed and in working order.
The warranty becomes effective upon verification of proper
installation.
DO NOT WORK AROUND THE CONVEYOR BELT
WITH LONG HAIR, LOOSE CLOTHING, OR DANGLING
JEWELRY. GETTING CAUGHT IN THE BELT COULD
RESULT IN DISMEMBERMENT OR FATAL INJURY.
7
CAUTION

Publicité

loading

Ce manuel est également adapté pour:

Ultra max um1833a