Publicité
Les langues disponibles
Les langues disponibles
Press again ↑ to select the second option, Mode. Press the key ↓ to
•
choose between:
Active when perimeter arming- usually assigned to sensors or magnetic
contacts on exterior (perimeter) doors and windows. The sensor is active when
the system is fully armed or partially armed.
Inactive when perimeter arming- usually assigned to a sensor (eg motion
sensor) in an interior area (eg living room, hall, bedroom). The sensor remains
inactive if the system is partially armed.
24 hours active- usually assigned to an area that contains an emergency
button, smoke sensor, CO sensors, flood sensors and gas sensors.
To use the sensor as a doorbell, select Doorbell.
To deactivate the sensor, select Close.
•
Press again ↑ to select the third option, where you will select using the key
↓ the number of the zone where the respective sensor will be assigned.
0-89 numbers are available. The zone number must be unique.
•
Press the key √. The message Synchronising appears on the screen.
The system enters pairing mode and counts the remaining pairing time
(maximum 20 sec.)
•
Trigger the sensor to send a pairing signal towards the control panel.
After pairing, the message Learning OK will be displayed.
•
Edit/Delete a sensor
•
In the main menu, select: Parts->Detector->Edit
•
Press the key ↑ to select the first option that contains the position on
which the sensor to be edited was saved. Press the button ↓ to reach the
desired position.
•
Press again ↑ to switch between options and the ↓ key to change the
values of an option.
Delete all sensors
•
In the main menu, select: Parts->Detector->Delete all
•
Press the key √ to confirm.
19
English
Publicité
