Télécharger Imprimer la page

Kohler PRO 5.4 DES Manuel Du Propriétaire page 6

Publicité

Les langues disponibles

Les langues disponibles

Cable Selection
Generator
10 A
Socket Type
Recommended
Cable Cross
Section
0 to
4
10
50 m
Length
of
51 to
100 m 10
7
Cable
Used
101 to
10
7
150 m
1
This cable length is maximum permitted
1
length, and must not be exceeded.
Installation method=cables on raceway
or non-drilled tablet/Permitted drop in
voltage=5%/Multi-core conductors/Cable
type PVC 70°C (e.g. H07RNF)/Ambient
temperature=86° F (30° C).
Maintenance Instructions
Accidental Starts can cause
severe injury or death.
Disconnect and ground spark
plug lead(s) before servicing.
Safety is an obligation of owner. Periodic inspection, adjustment and lubrication will keep your
generator in safest and most effi cient condition possible. Most important points of generator
inspection, adjustment, and lubrication are explained on following pages.
Maintenance Schedule
After fi rst 50 Hours of operation
● Service/replace precleaner (K).
● Change oil and fi lter (AE).
Every 250 Hours
1
● Change oil.
● Replace air cleaner element (L).
● Replace fuel fi lters (G).
Every 500 Hours
1
● Replace internal oil fi lter (AE).
● Replace fuel fi lters (G).
● Clean fuel tank.
● Clean spark arrester.
Every 500 Hours
2
● Set and clean injectors.
1
Perform these procedures more frequently under severe, dusty, dirty conditions.
Have a Kohler portable dealer perform this service.
2
6
All manuals and user guides at all-guides.com
16 A
32 A
6
9
10
7
10
7
25
3
16
5
35
2
WARNING
Before working on generator or equipment,
disable engine as follows: 1) Disconnect spark
plug lead(s). 2) Disconnect negative (–) battery
cable from battery.
Do not allow children to operate generator.
KohlerPower.com
Stopping
1. Disconnect electrical devices and allow
engine to run without any load for 1-2
minutes.
2. Turn MODYS (S) key to OFF position
(generator stops).
3. Open engine access door (E), close fuel
valve (I).
4. Close engine access door (E).
Engine Speed
NOTE: Do not tamper with governor setting to
increase maximum engine speed.
Overspeed is hazardous and will void
warranty.
38 590 01 Rev. B

Publicité

loading