Publicité
• Before installing the automatic system read the instructions hereunder carefully.
• It is strictly forbidden to use the product VN.M for applications other than indicated in this instruction hand-
book.
• Show the user how to use the automation system.
• Give the user the part of the leaflet which contains the instructions for users.
• All Benincá products are covered by an insurance policy for any possible damages to objects and persons
caused by construction faults, under condition that the entire system be marked CE and only Benincá parts
be used.
This geared motor has been studied and manufactured to activate balanced sectional doors (VN.M20/VN.MT20)
as well as rolling doors (VN.M40/VN.MT40) and sliding doors for industrial use.
Before proceeding to install the system, make sure that the door is balanced and slides well. Check that the
ropes, the springs and the parachuting system are in good conditions. For doors that have not been installed
recently, check also all the other parts subject to wear and tear. The above instructions are essential for the
safety of the system and the reliability of the operator.
Thanks to its versatility, this geared motor can be assembled not only on the right-side or left-side of the door,
but also horizontally or vertically (fig. 2). The geared motor has been designed to directly activate the cable
winding shaft of the door which must feature 1" diameter (25.4mm) and should be provided of housing for
the key. For cable winding shafts having a different diameter, an adapter should be provided (item VN.A30
for diam. 30 shafts, item VN.A3175 for diam. 31.75 shafts, item VN.A40 for diam. 40 shafts).
To fit the unit proceed as follows:
• Make sure that the distance between the cable winding shaft and the surface to which the bracket should
be fitted ranges between 82 and 150mm (as per fig. 3).
• Weld or fit the bracket S with screws to the surface.
• Insert the feared motor in the cable winding shaft.
• Tighten the screws inserting the tightening key C first.
To calculate the movement speed of the door, proceed as follows:
V (door speed) = d (diam. of cable winding drum - m) x 3.14 x 24 = m/1'
It is possible to use the geared motor by extending the motion to the rope winding-up shaft by means of a
chain (item VN.RM). The motion can possibly be transmitted reduced or multiplied (item VN.RV) (fig. 4).
To calculate the movement speed of the door, proceed as follows:
V (door speed) = d (diam. of cable winding drum - m) x 3.14 x 24 x Z1 / Z2 = m/1'
The geared motor is equipped with 4 microswitches: 1 is the opening limit switch (red cam), 1 the opening
over-travel (blue cam), 1 closing limit switch (yellow cam) and 1 is at disposal of the accessories (black cam),
N.C. max. 3A, 24Vac/dc max. To adjust the cams proceed as follows (fig. 10):
• Put a screwdriver in the hole F to avoid the rotation of the shaft.
• Loosen the nut D to allow rotation of the cam with a very reduced resistance.
• Manually move the door until it is almost completely close and adjust the yellow cam.
• Repeat the operation while opening the door and adjust the red cam.
• Then position the blue cam so that it is activated slightly delayed with respect to the red cam.
• Power the automatic unit and operate it (if it is a closing operation, invert wires 1 and 3 of the motor power
supply, fig. 6 and 7) while adjusting the closing cam (yellow) with slight adjustments as per fig. 11.
• Slightly tighten nut D.
12
All manuals and user guides at all-guides.com
Warning
Operating limits and warnings
Installation
Adjustment of the limit switches
Publicité
