Jensen MP1516 Manuel Du Propriétaire page 37

TROUBLESHOOTING
Before going through the checklist, the check wiring connections. If any of the
problems persist after checking the list, contact your nearest service dealer.
Problem Cause
No power. • The car ignition switch is
not on.
• The fuse is blown.
Disc cannot • A disc is loaded inside the
be loaded or player.
ejected.
• The transport screws are
installed.
Disc does • The disc is inserted in the
not play wrong direction.
back.
• Incompatible disc is used.
• Disc is warped or scratched.
• The compact disc is
extremely dirty or defective.
• The laser pickup is dirty.
• The temperature inside the
car is too high.
• Condensation.
No sound. • The volume is at minimum.
• The wiring is not properly
connected.
Sound skips. • The installation angle is
greater than 30 degrees.
• The disc is extremely dirty.
• The disc is defective.
All manuals and user guides at all-guides.com
MP1516
Solution
• If the power supply is
connected to the car
accessory circuits, but the
engine is not running, switch
the ignition key to "ACC".
• Replace the fuse. Make sure
the amperage matches the
specified value.
• Remove the disc in the player,
then insert a new one.
• Remove the two transport
screws from the top of the
unit.
• Insert the compact disc with
the label facing upward.
• Use a compatible disc.
• Use disc in good condition.
• Clean the disc with a soft cloth
or try to play a new one.
• Clean the laser pickup with a
cleaning disc.
• Cool off until the temperature
returns to normal.
• Turn the player off for an hour,
then try again
• Adjust the volume to a desired
level.
• Check the wiring connection.
• Adjust the installation angle
to less than 30 degrees.
• Clean the compact disc.
• Play a new compact disc.
37