Jensen MP1516 Manuel Du Propriétaire page 11

2. Bend the tabs on the mounting sleeve to keep the mounting sleeve firmly in
place.
3. Attach the wires from the unit to existing wires. See the wiring connections
diagram. Insert the radio into the dashboard. Then apply the trim frame to the
outside of radio.
4. Support the radio using the supplied rear mounting bolt and steel bar. See the
parts list.
DINRearMount(MethodB)
This method of installation uses the screw holes at the sides of the unit and the
holes of the existing vehicle mounting bracket. This is only intended as a general
guide; contact the vehicle's manufacturer for specific instructions.
NOTE: Outer trim frame, hook, and mounting sleeve are not used for this
installation.
All manuals and user guides at all-guides.com
MP1516
11