Workshop WS1600SS0 Manuel Du Propriétaire page 6

SP6851 Workshop 7/23/12
REMOVING/INSTALLING THE METAL
HANDLE
The metal handle comes packaged in the
carton in the reverse direction. The metal
handle must be removed from the handle
receptacles and reinstalled in the correct
position. Remove the metal handle by
pressing and holding in the release
buttons, while pulling handle upwards.
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.
Lowering Handle for Storage
To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
Installing Accessory Bag
Install Accessory Bag as shown with
extension wand holders facing unit.
Accessory Bag Snaps
10:39 AM Page 6
(Applies Only to WS1600SS0)
Correct
Position
Accessory
Bag Straps
(4)
Handle
Extension
Wand
Storage
Locations
6
Metal Handle in
Reversed Position
(As Shipped)
Moving
Position
Storage
Position