Workshop WS1600SS0 Manuel Du Propriétaire page 13

SP6851 Workshop 7/23/12
Emptying the Drum
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the
drum.
2. Another option is to remove the
powerhead assembly and dump the
drum contents into the proper waste
disposal container.
!
WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
Blowing Feature
Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
1. Locate blowing port of your Vac.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
!
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
10:39 AM Page 13
OPERATION
1. Locate blowing port of your Vac.
2. Insert the locking end of the Dual-
3. (Optional) Attach extension wand to
4. Turn Vac on and you are ready to use
13
(continued)
Flex™ Locking Hose into the blowing
port of the Vac. The hose should snap
into place. To remove the hose from the
Vac, press the release button in the
hose assembly and pull the hose out of
the Vac inlet.
opposite end of hose, then place the
car nozzle on the wand.
your Vac as a Blower.
Dual-Flex
Locking
Hose
Extension
Wand
(Optional)
Car Nozzle (Optional)
Blowing
Port
Swivel
End of
Hose