Clarity Professional C4230HS Mode D'emploi page 11

All manuals and user guides at all-guides.com
TROUBLESHOOTING
Phone Will Not Hold Charge:
• Make sure the charging contacts on the handset and base
are free of dust and dirt. While unplugged, clean the contacts
with a soft cloth.
• Make sure CHARGE LED on the base is lit when the handset
is in the cradle.
• Handset battery may have developed a memory, due to user
improperly charging, and may need to be replaced. (Battery
must be charged a full 12 hours before the first use.)
Difficulty in Placing or Receiving Calls:
• Move closer to the base and try again.
• Make sure you have selected the correct dialing mode, tone
or pulse.
• Make sure the AC Adapter is not plugged into a wall outlet
with other appliances. Disconnect for 5-10 seconds then
reconnect. Place the handset back on the base and reinsert
the AC Adapter.
• Make sure the handset battery is fully charged.
Your handset screen is showing Out of Range
• Move closer to the base.
• To register the C4230HS, place the C4230HS handset into the
main unit until the screen displays: Handset Registered. It will
take approximately 5-10 seconds for the handset to register
to the base.
• Handset may need to be re-registered to the base manually.
First, select INITIAL SETUP on the main menu. Second, select
REGISTRATION on the sub-menu.The screen will then display
"Please hold the page button until beep." This will register your
handset to the base.The screen will then display the
handset number.
11