Publicité
Les langues disponibles
Les langues disponibles
Start-up procedure
Warning!
Never allow the motor to run in closed spaces.
Poisoning danger!
Warning!
Do not use compressed starting fluid. Explosion
Danger!
Warning!
Hold limbs at a distance from the equipment's
moving parts. Rotating parts!
Caution!
Starter cord can spring back to the motor faster
than the cord can be let loose.
Recoil danger!
Only start the motor and allow it to run outdoors
„
Only start motor in a horizontal position
„
Control oil level
„
Tie up long hair and take off jewelry
„
Do not wear loose fitting clothing
„
max. 20°
„
Start motor
(Illustrations C, D)
Starting with a cold engine, after longer periods of
storage and temperatures under 10°C:
1. Press pimer button "a" 6 times.
2. Press pimer button "b" 10 times.
3. Quickly pull out the starter cord and then allow it to
slowly roll up.
Do not press primer buttons when engine is warm.
Engine speed (rpm value) is fixed.
Engine speed cannot be adjusted.
Caution!
Running motors produce heat. Motor parts,
particularly the exhaust, become extremely hot.
Burn danger!
474665_b
Hold hands and feet at a distance from rotating
„
parts
Hold flammable foreign objects far from the
„
exhaust and cylinder area
Allow exhaust, cylinders and cooling fins to cool
„
before touching
Storage
Storing motor
Caution!
Do not store motor near open flames or heating
sources - Burn and/or explosion danger!
Allow motor to cool
„
Store motor in a well ventilated room, not in the
„
vicinity of open flames or heating sources
Avoid the following areas when storing:
„
Proximity to open flames
„
Proximity to heating sources
„
where electrical motors are operated
„
where electrical tools are used
„
With motors that are stored longer than 30 days,
„
that drain fuel or are protected with a stabilizer,
since they otherwise form deposits in the fuel
system
Calibration
Danger!
Before callibration, maintenance and repair work,
always turn off the motor and secure it.
Pull ignition wire and hold at a distance from the
„
spark plug
Carburetor Adjustment
Carburetor callibration may only be carried
out by authorized workshops or by our customer
service department.
GB
13
Publicité
