Publicité
Les langues disponibles
Les langues disponibles
WARNING
Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to maintain
a balanced working position.
Before starting work on electrical equipment, please ensure that either there are no live
parts in the immediate working area or that precautions are taken for working near live
parts in accordance with EN50110-1.
Do not use this tool on or near energised conductors without proper personal protective
equipment. Failure to observe this warning could result in severe injury or death.
The tool is unsuitable for continuous use and should be allowed to cool down following
uninterrupted, successive crimping operations; for instance, having exhausted a fully
charged battery in one session, delay battery replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery. Electro--
hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
IMPORTANT: Never pressurise the tool without inserting the dies, this could cause damage
to the head and the ram.
The part reference includes the following (Ref. to Fig. 6 page 45):
Hydraulic crimping tool.
Li-Ion rechargeable battery (2 pcs).
Battery charger.
Shoulder strap.
Plastic carrying case.
USB cable (Ref. to § 5).
2.1) Preparation
The tool can be easily carried using either the main handle (11) or the shoulder strap attached to
the two rings (7) (Ref. to Fig. 5).
The main operating positions are: horizontal standing on its feet and vertical standing on its bat-
tery. In addition to the main handle (11) the lower handle (5) allows a safer and more balanced grip
when using two hands to hold the tool (Ref. to Fig. 3).
Before starting any work, check the battery charge (Ref. to § 2.8) and recharge if necessary,
following the instructions in the battery charger user manual.
6
Publicité
