PRO-POINT 8300139 Mode D'emploi page 7

8300139
Tool Rest
A. 2 x Carriage bolt, 5/16-18 x 1-1/2 in.
B. 2 x Tool rest
C. 6 x Flat washer, 5/16 in.
D. 2 x Hex nut, 5/16-18 in.
E. 2 x Bracket
F. 4 x Hex bolt, 5/16-18 x 3/8 in.
ASSEMBLY
When this manual refers to a part number, it refers to the included Parts Identification section.
WARNING ! Do not connect grinder to the power source until all assembly steps have
been completed.
EYE SHIELD ASSEMBLY
Refer to Figure 1.
1. Fasten spark guard (K) to wheel guard using hex bolt (J), lock washer (I) flat washer (H) and
serrated washer (A). The serrated washer must be placed between spark guard and wheel
guard surfaces for added stability.
2. Remove pan head screws (B) from the eye shield assembly.
3. Mount left upper eye shield bracket (C) to eye shield (E) using pan head screws (B) and
lower eye shield bracket (D).
IMPORTANT! Left upper eye shield bracket is stamped "L" for identification.
4. Slide knob (G) through 6 mm flat washer (F) and through hole at top of spark guard (K) and
fasten into upper eye shield bracket (C).
5. Locate eye shield in desired position for protecting operator and tighten knob.
6. Mount right eye shield assembly in a similar manner.
TOOL REST ASSEMBLY
Refer to Figure 2
1. Attach bracket (E) to wheel guard using hex bolts (F) and flat washers (C).
2. Tighten bolts finger-tight.
3. Slide 5/16 in. -18 carriage bolt (A) into square hole in tool rest bracket (E).
4. Slide tool rest (B) onto carriage bolt from the inside of tool rest as shown in Fig. 2.
5. Slide 5/16 in. flat washer (C) and 5/16 in. -18 hex nut (F) onto carriage bolt (A).
6. Tighten nut finger-tight.
7. Position tool rest so that distance between tool rest and grinding wheel is a maximum
of 1/16 in.
8. Secure all nuts and bolts.
9. Mount the opposite side tool rest in a similar manner.
Visit www.princessauto.com for more information
6 in. Bench Grinder
Fig. 2
V 3.03
7