Publicité
Les langues disponibles
Les langues disponibles
8300139
8. Never touch the grinding wheel or work piece during or immediately after use. The grinding
wheel or work piece will be too hot to be touched by bare hands.
9. Replace cracked wheel immediately. Use only flanges supplied with the grinder.
10. Clean dust and debris from beneath the grinding wheels frequently.
GENERAL SAFETY PRECAUTIONS
ELECTRICAL SAFETY
WARNING! To reduce risk of electric shock, be certain that the plug is connected to a properly
grounded receptacle.
1. Disconnect tool from power source before cleaning, servicing, changing parts/accessories or
when not in use.
2. Protect yourself against electric shocks when working on electrical equipment. Avoid body
contact with grounded surfaces. There is an increased chance of electrical shock if your body
is grounded.
3. Do not expose tool to rain or wet conditions. Water entering a power tool will increase the
risk of electric shock.
4. Do not disconnect the power cord in place of using the ON/OFF switch on the tool. This will
prevent an accidental startup when the power cord is plugged into the power supply.
5. Do not alter any parts of the tool or accessories. All parts and accessories are designed with
built-in safety features that may be compromised if altered.
7. Make certain the power source conforms to requirements of your equipment.
8. When wiring an electrically driven device, follow all electrical and safety codes, as well as the
most recent Canadian Electrical Code (CE) and Canadian Centre for Occupational Health and
Safety (CCOHS).
9. This device is only for use on 120 V (single phase) and is equipped with a 3-prong grounded
power supply cord and plug.
10. DO NOT use this device with a 2-prong wall receptacle.
10.1 Choose an available 3-prong power outlet.
10.2 Replace 2 prong outlet with a grounded 3-prong receptacle, installed in accordance
with the CE Code and local codes and ordinances.
WARNING! All wiring should be performed by a qualified electrician.
POWER CORD
1. Insert the power cord plug directly to the power supply whenever possible. Use extension
cords or surge protectors only when the tool's power cord cannot reach a power supply from
the work area .
1.1
Use in conjunction with a Ground Fault Circuit Interrupter (GFCI). If operating a power
tool in a damp location is unavoidable, the use of a GFCI reduces the risk of electric
shock. It is recommended that the GFCI should have a rated residual current of
30 mA or less.
2. Do not operate this tool if the power cord is frayed or damaged as an electric shock may
occur, resulting in personal injury or property damage.
2.1
Inspect the tool's power cord for cracks, fraying or other faults in the insulation or plug
before each use.
2.2 Discontinue use if a power cord feels more than comfortably warm while operating
the tool.
2.3 Have the power cord replaced by a qualified service technician
3. Keep all connections dry and off the ground to reduce the risk of electric shock. Do not
touch plug with wet hands.
Visit www.princessauto.com for more information
6 in. Bench Grinder
V 3.03
5
Publicité
