Publicité
Les langues disponibles
Les langues disponibles
V 3.03
4. Prevent damage to the power cord by observing the following:
4.1
Never use the cord to carry the tool.
4.2 Do not pull on the cord to disconnect the plug from an outlet.
4.3 Keep the power cord clear of the tool and the tool's work path while in operation. The
cord should always stay behind the tool.
4.4 Keep cord away from heat, oil, sharp edges or moving parts.
5. Do not allow people, mobile equipment or vehicles to pass over unprotected power cords.
5.1
Position power cords away from traffic areas.
5.2 Place cords in reinforced conduits.
5.3 Place planks on either side of the power cord to create a protective trench.
6 Do not wrap cord around tool as sharp edges may cut insulation or cause cracks if wound
too tight. Gently coil cord and either hang on a hook or fasten with a device to keep cord
together during storage.
USE AND CARE OF TOOL
1. Use the correct tool for the job. This tool was designed for a specific function. Do not modify
or alter this tool or use it for an unintended purpose.
2. Avoid unintentional starts. Be sure that the ignition switch/trigger is in the neutral or OFF
position when not in use or before connecting it to any power source.
PARTS IDENTIFICATION
WARNING! Do not operate the tool if any part is missing. Replace the missing part before
operating. Failure to do so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage. Make sure that all
items in the parts list are included.
Contents:
•
Bench Grinder
•
2 x Tool Rest
•
2 x Eye Shield
•
Hardware
•
2x 6 in. Grinding Wheel (already installed)
Eye Shield
A. 2 x Serrated washer, 8 mm
B. 4 x Pan head screw, #10-24 x 3/8 in.
C. 2 x Upper eye shield bracket (left and right)
D. 2 x Lower eye shield bracket
E. 2 x Eye shield
F. 2 x Flat washer, 6 mm
G. 2 x Knob
H. 2 x Flat washer, 1/4 in.
I.
2 x Lock washer, 1/4 in.
J. 2 x Hex bolt, 1/4-20 x 3/8 in.
K. 2 x Spark guard (left and right)
6
6 in. Bench Grinder
Fig. 1
For technical questions call 1-800-665-8685
8300139
Publicité
