Publicité
Les langues disponibles
Les langues disponibles
8. Remove the blade by unscrewing
and pulling out the knob at the back of
the slicer (Figure 6).
This will allow you to remove the plate
on top of the blade. You need a Phillips
head screwdriver to remove the 3
screws securing the blade to the unit.
Carefully pull the Blade off the unit
(Figure 7).
9. Remove the blade support by
removing the bolt from the top of
the motor housing. Remove the (2)
Phillips head screws, (2) washers and
(2) recessed nuts from the back right
side of the motor housing (Figure 8).
Unscrew the (2) nuts at the bottom of
the blade support (Figure 9).
10. To remove the gauge plate, unscrew
the cap nuts and remove the washers
from the back of the gauge plate.
All manuals and user guides at all-guides.com
CAUTION
SHARP Blade
Blade
Locking
Screw
-9-
Figure 6
Figure 7
Figure 8
Figure 9
Publicité
