Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the bat-
tery cartridge is removed before carrying out any work on
the tool.
Oil replenishment (Fig. 16)
This cordless rod cutter is electrohydraulic. When
shipped from the factory, it was filled with the oil. Do not
attempt to add oil as long as the tool performs well. When
the oil-pressure is not enough to cut steel rods, replenish
the oil as follows. Use only Genuine Makita Hydraulic Oil
#46.
1.
Place the steel rod between the cutters and pull the
trigger.
2.
Release the trigger just before cut-off is completed
to stop the tool.
3.
Remove the battery cartridge from the tool.
4.
Remove the hex bolt which caps the oil hole.
Replenish oil, being careful not to allow any oil into
the motor.
5.
Replace the hex bolt and tighten securely.
6.
Install the battery cartridge on the tool and complete
cut-off of the steel rod.
7.
Repeat the above procedures several times.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Cutter
• Balance stand
• Oil #46
• Battery cartridge 1822/1833/1834/1835
• Fast charger DC1439
• Battery charger Model DC1803
• Battery cover
• Plastic carrying case
11
Publicité
