Tripp-Lite SmartOnline Serie Manuel Du Propriétaire page 4

Installation
2-Post (Telecom) Mounting
If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post
Rackmount Installation Kit (model: 2POSTKITRMWM, sold separately). See Installation Kit owner's
manual for installation procedure for 2U UPS models.
Mounting (Tower)
Your UPS can be mounted in an upright tower
position with optional base stands sold
separately by Tripp Lite (Model # 2-9USTAND).
When mounting the UPS on adjustable base
stands, make sure that the control panel is
toward the top. The control panel may be
rotated to make it easier to read. Insert a small
screwdriver or similar tool in the slots on either
side of the panel, pop it out, rotate it, and pop
it back into place as shown.
WARNING!
All UPS systems are extremely heavy. Use
caution when lifting and mounting. User
must properly stabilize the UPS when lifting
and mounting.
Connection and Start-Up
1
Plug your UPS's line cord into an
electrical outlet.
Your UPS must be connected to a
dedicated circuit of sufficient amperage.
Note, however, that the select models may
be fitted with different plug types. Refer to
the "OP Rating/Plug Rating" chart printed
on the top of your UPS.
Once your UPS is plugged in, the fan and
all Indicator Lights will turn ON. The "LINE"
and "LOAD ACTIVE METER" LEDs will
illuminate and the UPS will emit a beep to
indicate normal operation. However, power
is not supplied to your UPS's AC outlets
until the UPS is turned on.
2
Plug your equipment into your UPS.
Your UPS is designed to support computer
equipment only. You will overload your UPS
if you connect household appliances or
laser printers to the UPS's outlets.
201102199 93-2471.indb 4
All manuals and user guides at all-guides.com
1
2
4
Your model may differ.
Your model may differ.
3/30/2011 9:14:00 AM