Tripp-Lite SmartOnline Serie Manuel Du Propriétaire page 3

Installation
Rack Mounting
Mount your equipment in either a 4-post or 2-post rack or rack enclosure (see next page for 2-post
mounting). The user must determine the fitness of hardware and procedures before mounting. If
hardware and procedures are not suitable for your application, contact the manufacturer of your
rack or rack enclosure. The procedures described in this manual are for common rack and rack
enclosure types and may not be appropriate for all applications.
4-Post Mounting
All UPS models include hardware required to mount in a 4-post rack. Select models include an
adjustable rackmount shelf kit to provide additional support. If your UPS model does not include
an adjustable rackmount shelf kit, skip steps 1 and 2.
1
Connect the two segments of each shelf
using the included screws and nuts
Leave the screws slightly loose so that the
shelves can be adjusted in the next step.
2
Adjust each shelf to fit your rack, then
mount them in the lowest available space
of your rack with the screws, nuts and
washers provided
ledges should face inward. Tighten the
screws that connect the shelf segments
3
Attach mounting ears
mounting holes of your equipment
the screws provided
face forward.
4
Using an assistant if necessary, lift your
equipment and slide it onto the mounting
shelves. Attach your equipment to the rack
by using the appropriate hardware
through its mounting ears and into the rack
rails.
201102199 93-2471.indb 3
All manuals and user guides at all-guides.com
A
B
.
C
. Note that the support
B
.
D
to the front
E
using
F
. The ears should
G
3
B
A
1
C
2
E
D
3
G
4
B
F
3/30/2011 9:13:59 AM