Bosch Perf Line KOGA Kiox BUI330 Manuel D'instructions page 57

English – 8​
Error code display
The eBike system's components are continuously and auto-
matically monitored. If an error is detected, the correspond-
ing error code is displayed on the on-board computer.
The drive may be automatically shut down, depending on the
type of error. However, if you wish to continue cycling, you
Code Cause
410 One or more buttons of the on-board com-
puter are disabled.
414 Operating unit connection problem
418 One or more buttons on the operating unit
are disabled.
419 Configuration error
422 Drive unit connection problem
423 eBike battery connection problem
424 Communication problem between com-
ponents
426 Internal time-out error
430 Internal battery of the on-board computer
is flat
431 Software version error
440 Internal drive unit fault
450 Internal software error
460 Error at USB port
490 Internal fault of the on-board computer
500 Internal drive unit fault
502 Bike light fault
503 Speed sensor fault
504 Speed signal distortion detected.
510 Internal sensor fault
511 Internal drive unit fault
530 Battery fault
531 Configuration error
1 270 020 XBK | (12.03.2019)
will always be able to do so without assistance from the
drive. Before undertaking any other journeys, the eBike
should be checked.
Have all repairs performed only by an authorised bike
u
dealer.
Corrective measures
Check whether any buttons are stuck, e.g. as a result of dirt finding
its way in. Clean the buttons if need be.
Have the connections checked
Check whether any buttons are stuck, e.g. as a result of dirt finding
its way in. Clean the buttons if need be.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Have the connections checked
Have the connections checked
Have the connections checked
Restart the system. If the problem persists, contact your Bosch
eBike dealer. With this error, it is not possible to bring up the wheel
circumference in the basic settings menu or to adjust it.
Charge the on-board computer (in the holder or via the USB port)
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Remove the cable from the USB port of the on-board computer. If
the problem persists, contact your Bosch eBike dealer.
Have the on-board computer checked
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Check the light and the associated wiring. Restart the system. If
the problem persists, contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Check that the spoke magnet is positioned correctly, and adjust it
if necessary. Check that nothing has been tampered with (tuning).
Drive assistance is reduced.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Switch off the eBike, remove the eBike battery and reinsert the
eBike battery. Restart the system. If the problem persists, contact
your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Bosch eBike Systems