Publicité
Les langues disponibles
Les langues disponibles
6.
Your device runs in music mode:
7.
Control the music-sensitivity with the trim pot at the front panel. The LED is
flashing when the device is triggered.
Your device runs in DMX mode if '10' is switched off:
8.
Connect a DMX controller to operate the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch
represents a number. To define a number use the preceding number and
multiply it by 2:
Switch
1
2
3
4
Number 1
2
4
8
The laser uses 13 DMX channels, so make sure that the next device uses an
address that doesn't overlap with this range.
Channel
Value
1
0 - 63
64 - 125
126 - 191
192 - 255
2
0 - 255
3
0 - 255
4
0 - 255
5
0 - 255
6
0 - 255
7
0 - 255
8
1- 39
40 - 79
5
6
7
8
9
10
16
32
64
128
256
Mode Switch
Function
Laser off
Sound mode
Automatic mode
DMX mode
Pattern selection
Strobe effect
Point speed
x axis positioning
y axis positioning
Zoom / size
Color: yellow
Color: red
Channel
Value
80 - 119
120 - 159
160 - 199
9
above 200
10
1 - 79
80 - 199
>200
11
0 - 150
151 - 255
12
0 - 180
181 - 217
218 - 255
13
0 - 100
101 - 130
131 - 255
Please note that each pattern can be combined with each effect.
9.
To turn off the device switch it off („OFF"), switch the key to „OFF" and
disconnect the power cable from the mains.
Function
Color: green
original patterns
color change
Reset (shortly)
drawing (increasing part of the
pattern)
see above: automatically with
increasing speed
Reset (shortly)
mirorring y axis (increasing part
of the pattern)
see above; automatically
Rotation around its own axis
(clockwise)
Auto-rotation around its own
axis (clockwise)
Auto-rotation around its own
axis (counter clockwise
pattern (starting from rigth
to left)
see above (automatically)
see above (automatically incl.
color changing)
Publicité
