Pioneer KURO KRP-S02 Mode D'emploi page 9

INSTALLATION ON THE FLAT PANEL DISPLAY
Flat panel display with the speaker installed
Speaker bracket
(for TOP-Right)
Speaker mounting
screw (M5 × 10 mm)
Speaker
Speaker bracket
(for BOTTOM-Right)
Speaker mounting
screw (M5 × 10 mm)
*: Accessories of the flat panel display
When using the table top stand:
NOTE:
Before attaching the speaker, please attach the KRP-TS01 series table top stand (or another flat panel display stand) to the flat panel
display.
1. Attaching the Speaker Brackets to the Speakers.
There are top and bottom speaker brackets for both the left and the right speakers. Attach the appropriate brackets to the top
and the bottom on the back of the speakers using the supplied screws.
(It shows the attachment of the bracket on the right side. It is attached on the left side by the same procedure.)
Speaker bracket
(For TOP-Right)
Speaker bracket
(For BOTTOM-Right)
Speaker mounting
screw (M5 × 10 mm)
Speaker mounting
screw (M5 × 10 mm)
Cable clamp*
Screw holes
Get other manuals https://www.bkmanuals.com
Speaker mounting
screw (M5 × 10 mm)
Speaker mounting
screw (M5 × 10 mm)
Speaker cable*
Cable clamp*
Speaker bracket
(For BOTTOM-Right)
English
Speaker bracket
(for TOP-Left)
Speaker mounting
screw (M5 × 10 mm)
Speaker
Speaker bracket
(for BOTTOM-Left)
Speaker mounting
screw (M5 × 10 mm)
Screw holes
Speaker bracket
(For TOP-Right)
Place the speaker so its
terminals (bottom) are
facing you.
9