Publicité
Les langues disponibles
Les langues disponibles
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting Procedure
section (page US-17).
If the engine fails to start after you follow the
above procedures, contact an authorized
Maruyama dealer.
To Stop The Engine
1. Release the throttle trigger.
2. Slide the stop switch to the "STOP" position.
Fast-idle start lock
STOP(OFF)
Stop switch
Operation
WARNING
POTENTIAL HAZARD
• The Pruner can conduct electricity.
WHAT CAN HAPPEN
• Contact with live electrical wires or circuits
can cause serious injury or death.
HOW TO AVOID THE HAZARD
• Never use the Pruner around electrical lines,
circuits or components.
CAUTION
• Read the Safety instructions on page US-11
concerning proper use of the Pruner.
Before using the Pruner, check the following:
1. Make sure the chain oil tank on the pruner head is full.
All manuals and user guides at all-guides.com
START(ON)
Fast-idle start
position
Idle position
IMPORTANT: When filling an empty oil tank, wait
approximately 60-90 seconds before starting the
Pruner. This will give the oil time to flow from the
tank to the pump. Otherwise, an air lock can occur
which will prevent oil from moving through the
pump. This will result in damage to the chain and
guide bar.
IMPORTANT: Never run the chain dry.
2. The operator must be set the shaft assembly on the
operator's right side.
3. The operator's right hand should be holding the shaft
grip, with his or her fingers on the throttle trigger. The
right arm should be slightly bent.
4. The left hand should be holding the loop handle with the
fingers and thumb fully enclosed around the grip. The
left arm should be extended. Reposition the loop handle
up or down the driveshaft if necessary for a comfortable
position.
Hearing Protection
Right Arm
Slightly Bent
Hand Holding Throttle Grip,
Fingers on Throttle Trigger
― US - 18 ―
Eye Protection
Left Arm Fully Extended,
Hand Holding Loop Handle
Publicité
