Publicité
Les langues disponibles
Les langues disponibles
en-us_main.book.book Page 12 Wednesday, January 25, 2023 8:53 AM
12 INSTALLATION
WARNING
- It is the personal responsibility and obligation
of the product owner to have a proper outlet
installed by a qualified electrician.
CAUTION
• When connecting the dishwasher water supply
line to the house water supply, sealing tape or
compound should be used on pipe threads to
avoid leaks. Tape or compound should not be
used on compression fittings.
• Connect the dishwasher to a hot water supply
with a temperature range between 120 °F (49 ℃)
and 149 °F (65 ℃). This temperature range
provides the best washing results and shortest
cycle time. To prevent damage to dishes, the
temperature should not exceed 149 °F (65 ℃).
• Water supply pressure must be between 20 psi
and 80 psi (140–550 kPa). If the water supply
pressure exceeds 80 psi, a pressure reducing
valve must be installed. Otherwise premature
failure of the inlet valve may occur.
Routing Water Supply Line and
Electrical Wiring
There are 2 channels in the bottom of the
dishwasher for routing the water and electrical
connections.
• As shown in the bottom view below, channel
is for the water supply line, and channel
the electrical cable.
1
Turn off the house water supply and the
circuit breaker or dedicated power before
connecting the dishwasher.
2
Run the water supply line along the floor 6 1/
2" – 7 3/4" (165 mm – 197 mm) from the left
side of the opening and tape it in place in
front of the opening.
3
Run the electrical cable
– 16" (356 mm – 406 mm) from the water
supply line
• The electrical outlet must be within 4 ft.
(1.22 m) of either side of the dishwasher.
• The best location for the electrical conduit is
on the right side of the back wall. Re-route
the electrical cable before installation if the
electrical conduit pipe is longer than 3" (76
mm) and is centered on the back wall.
Preparing Dishwasher
WARNING
• Do not remove safety cover
result in fire, electric shock or death.
a
b
is for
Releasing Drain Hose
Remove the twist tie holding the drain hose to the
back of the shipping brace.
c
along the floor 14"
d
and tape it in place.
a
. Removal can
Publicité
