GE SBSD107H Utilisation Et Entretien page 38

Stacking
INSTALLING THE STACK BRACKET KIT, cont.
Place
hands
here
38
4. Prepare the Washer and Dryer
A. Place the washer in the approximate
location.
B. Make sure the washer is level. Refer
to washer Installation Instructions for
details.
C. Remove the back portion of the
control panel by removing the 3
screws.
5. Install Dryer and Bracket
on Washer
A. Lift the dryer on top of the washer. Be
careful not to scratch the top of the
washer with the brackets. Protect the
washer control panel with cardboard
or other protection. Be sure to lift
the dryer high enough to clear the
washer control panel.
WARNING!
Potential Personal Injury. More than two
people are recommended to lift the dryer
into position because of its weight and size.
Failure to do so could result in personal
injury or death.
6. Finalize the Installation
A. Refer to the washer Installation
Instructions to complete the washer
installation.
B. Refer to the dryer Installation
Instructions to complete the dryer
Place
installation.
hands
here
C. Carefully slide or walk the stacked
washer and dryer into place. Use felt
pads or other sliding device to assist
moving and to protect flooring.
D. Reverse dryer door swing if desired.
See dryer Installation Instructions for
details.
NOTE: The washer door swing is not
reversible.
B. Align the holes in the bracket with
the holes in the back of the washer.
Using a Phillips screwdriver, attach
the 2 #8 x 1/2" tapping screws.
Repeat on both sides of the washer.
WARNING!
Potential Personal Injury. Do not push
on the dryer once installed to top of
the washer. Pushing on the dryer may
result in pinched fingers.