Publicité
Les langues disponibles
Les langues disponibles
About cycle options
NOTE: Not all features are available on all dryer models.
Extend Tumble
Minimizes wrinkles by adding
approximately 60 minutes of no-heat
tumbling after clothes are dry. The
beeper will sound every 2 minutes to
remind you to remove the clothes. The
ESTIMATED TIME REMAINING display
will show 00.
Damp Alert
(on some models)
This option causes the dryer to beep
when clothes have dried to a damp
level. Remove items that you wish to
hang dry. The DAMP ALERT will only
beep when this option is selected.
Signal
Alerts you that the cycle is complete.
The beeper will continue to sound every
two minutes for the next 6 minutes,
until the clothes have been removed.
The clothes should be removed when
the beeper goes off so wrinkles don't
set in.
Delay Start
Use to delay the start of your dryer.
1. Choose your dry cycle and any
options.
2. Press DELAY START. You can change
the delay time in 1 hour increments
using the + or – arrow pads.
3. Press the START pad to start
the countdown.
The countdown time will be shown in
the ESTIMATED TIME REMAINING
display.
www.GEAppliances.ca
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.
Press SIGNAL to select low, medium or high
volume, or to turn the beeper off.
NOTE:
If the door is opened while the dryer is in
DELAY, the countdown time will not restart
unless the door is closed and START has been
pressed again.
You can delay the start of a dry cycle up to 18
hours, depending on the model.
25
Publicité
