Télécharger Imprimer la page

Jenn-Air JBRFR24IGX Instructions D'installation page 13

Masquer les pouces Voir aussi pour JBRFR24IGX:

Publicité

Les langues disponibles

Les langues disponibles

S I T E P R E P
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
4 . C H E C K T H E E L E C T R I C A L
 Column on a separate circuit. Outlet cannot
be turned off by a switch.
 Not using an extension cord.
 Not using a GFCI protected outlet.
 Electrical installed in the zones highlighted.
(See graphic to the right.)
I F YOU HAVE Q U E ST IO N S A BOUT YOU R ELECTRI CAL SU PPLY,
?
CAL L A L IC E NS E D, Q UA LI F I E D E LECTRI CIAN .
Before you move your refrigerator into its final location, it
is important to make sure you have the proper electrical
connection.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person. Do not use a cord that shows cracks or abrasion
damage along its length or at either the plug or connector
end.
Recommended Grounding Method
A 115 V, 60 Hz, AC only 15 A or 20 A fused, grounded
electrical supply is required. Maximum amp draw for one
column is 3.9 A. It is recommended that a separate circuit
serving only your refrigerator and approved accessories
be provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
IMPORTANT: If this product is connected to a GFCI
(Ground Fault Circuit Interrupter) protected outlet,
nuisance tripping of the power supply may occur,
resulting in loss of cooling. Food quality and flavor may
be affected. If nuisance tripping has occurred, and if the
condition of the food appears poor, dispose of the food.
NOTE: Before performing any type of installation or
cleaning, turn the master power switch to OFF or
disconnect power at the circuit breaker box located
behind the lower toe kick. When you are finished, turn ON
the master power switch or reconnect power at the circuit
breaker box. Then reset the control to the desired setting.
13

Publicité

loading