Makita DHS680 Manuel D'instruction page 9

Bevel cutting
1
► 1. Front lever
Loosen the front lever. Set for the desired angle (0° -
50°) by tilting accordingly, then tighten the front lever
securely.
1
► 1. Stopper
Use the 45° stopper when you do precise 45° angle
cutting. Turn the stopper counterclockwise fully for
bevel cut (0° - 45°) and turn it clockwise for 0° - 50°
bevel cuts.
Sighting
1
3
► 1. Cutting line (0° position) 2. Cutting line (45° posi-
tion) 3. Screw
For straight cuts, align the 0° position on the front of
the base with your cutting line. For 45° bevel cuts, align
the 45° position with it. The position of the top guide is
adjustable.
0-45
0-50
2
Lighting the lamp
CAUTION:
• Do not look in the lamp or see the source of
lamp directly.
1
► 1. Lamp
Only to turn on the lamp, pull the switch trigger without
pressing the lock-off lever. To turn on the lamp and run
the tool, press the lock-off lever and pull the switch trig-
ger with pressing the lock-off lever. The lamp keeps on
lighting while the switch trigger is being pulled. The lamp
goes out 10 -15 seconds after releasing the trigger.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
• Do not use gasoline, thinner or the like to clean
the lens of lamp. Using such substances will
damage the lens.
Hook
CAUTION:
• Always remove the battery when hanging the
tool with the hook.
• Never hook the tool at high location or on poten-
tially unstable surface.
► 1. Hook 2. Close 3. Open
The hook is convenient for hanging the tool temporarily. To use
the hook, simply turn it until it snaps into the open position.
When not in use, always turn the hook until it snaps into
the closed position.
9 ENGLISH
1
3
2