Publicité
[i7 Raise the needle and foot. Place the automatic
buttonhole foot with its pin just under the groove of
the foot holder. Lower the presser bar to attach the
foot.
_i_ Groove
_2) Pin
[21 Pull the button holder open to the back (A), and
place the button in it. Push the button holder
closed (B) to hold the button.
_3_Button holder
NOTE:
If the button is extremely thick,
buttonhole. If it is difficult to
test buttonhole, le
the button hol,
_4_Gap
as far as it will
[3 Raise the buttonhole foot and draw the needle
thread to the left through the hole on the foot.
Place the fabric under the foot and lower the
needle at the starting point. Then lower the foot.
_6_Buttonhole mark
_7_Starting point
_8_Slider
_9_No gap
_# Spring holder
_ Sewing gap
NOTE:
Make sure there is no gap between the slider and
spring holder, otherwise the left and right length of
the buttonhole will be different.
[:i i1
J
Publicité
