Milwaukee M18 ONERSAL Notice Originale page 10

TECHNICAL DATA
Type
Battery voltage
Rated power input
Lighting time with two fully charged batteries (9.0 Ah)
High Level
Med Level
Low Level
Luminous flux
Mode High
Mode Medium
Mode Low
Colour rendering index (CRI)
Colour temperature
Frequency band(s) of Bluetooth
Radio-frequency power
Bluetooth version
Protection class
Weight without battery
Weight according EPTA-Procedure 01/2014 (2,0...9,0 Ah)
Recommended ambient operating temperature
Recommended battery types
Recommended charger
WARNING!
Read all safety warnings and all
instructions. Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS BATTERY-LAMP
Warning: Do not direct the light beam at persons or animals
and do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious injury
or vision loss.
The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be
replaced.
Caution – this product is provided with cooling openings in the
bottom enclosure. Only install this luminaire on a surface that
will not allow accumulation of water into the housing. Keep the
product away from puddles,etc.
SAFETY INSTRUCTIONS BATTERY
Remove the battery pack before starting any work on the
appliance.
Do not dispose of used battery packs in the household refuse
or by burning them. Milwaukee Distributors offer to retrieve old
batteries to protect our environment.
Do not store the battery pack together with metal objects (short
circuit risk).
Use only compatible Milwaukee chargers from the same battery
platform for charging battery packs. Do not use battery packs
from other systems.
Battery acid may leak from damaged batteries under extreme
load or extreme temperatures. In case of contact with battery
acid wash it off immediately with soap and water. In case of eye
contact rinse thoroughly for at least 10 minutes and immediately
seek medical attention.
WARNING This device contains a lithium button/coin cell
battery. A new or used battery can cause severe internal
burns and lead to death in as little as 2 hours if swal lowed
or enters the body. Always secure the battery cover. If it does
not close securely, stop using the device, remove the batteries,
and keep it away from children. If you think batteries may have
18
M18 ONERSAL
Battery-Lamp
18 V
46 W
7 h
12,5 h
26 h
5400 lm
3100 lm
1600 lm
70
4000 K
2402-2480 MHz
1,8 dBm
4.0BT signal mode
IP 67
8,7 kg
9,3...10,9 kg
-18 °C ... +50 °C
M18B...; M18HB
M12-18; M1418C6
been swallowed or entered the body, seek immediate medical
attention.
Warning! To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach containing products,
etc., can cause a short circuit.
SPECIFIED CONDITIONS OF USE
The battery lamp can be used as lighting independently of a
mains power supply.
Do not use this product in any other way as stated for normal
use.
ONE-KEY™
To learn more about the ONE-KEY functionality for this tool,
please reference the Quick Start guide included with this product
or go to www.milwaukeetool.com/one-key. To download the
ONE-KEY app, visit the App Store or Google Play from your
smart device.
Also, when the product experiences ESD, the Bluetooth
communication will be disconnected. It needs to be reset
manually to recover.
ONE-KEY™ Indicator
Solid Blue Wireless mode is active and ready to be
configured via the ONE-KEY™ app.
Blinking Blue Tool is actively communicating with the ONE-
KEY™ app.
Blinking Red Tool is in security lockout and can be
unlocked by the owner via the ONE-KEY™
app.
ENGLISH
NOTES FOR LI-ION BATTERIES
Use of Li-Ion batteries
Batteries which have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance
of the battery. Avoid extended exposure to heat or sunshine (risk
of overheating).
The contacts of chargers and batteries must be kept clean.
For an optimum life-time, the batteries have to be fully charged,
after used.
To obtain the longest possible battery life remove the battery
pack from the charger once it is fully charged.
For battery storage longer than 30 days:
Store the battery where the temperature is below 27°C and away
from moisture
Store the battery in a 30% - 50% charged condition
Every six months of storage, charge the battery as normal.
Transport of Li-Ion batteries
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance
with local, national and international provisions and regulations.
• The user can transport the batteries by road without further
requirements.
• Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and
insulated to prevent short circuit.
• Ensure that battery pack is secured against movement within
packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice.
MAINTENANCE
Use only Milwaukee accessories and Milwaukee spare parts.
Should components need to be replaced which have not been
described, please contact one of our Milwaukee service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the machine type printed as well as the six-digit No. on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
CAUTION! WARNING! DANGER!)
Remove the battery pack before starting any work
on the machine.
Do not swallow the coin cell battery!
Do not stare at the operating light source.)
Class III electrical protection.
Protection class
IP67
Do not dispose of waste batteries, waste electrical
and electronic equipment as unsorted municipal
waste. Waste batteries and waste electrical and
electronic equipment must be collected separately.
Waste batteries, waste accumulators and light
sources have to be removed from equipment.
Check with your local authority or retailer for
recycling advice and collection point.
According to local regulations retailers may have an
obligation to take back waste batteries and Waste
electrical and electronic equipment free of charge.
Your contribution to re-use and recycling of waste
batteries and waste electrical and electronic
equipment helps to reduce the demand of raw
materials.
Waste batteries, in particular containing lithium and
waste Electrical and electronic equipment contain
valuable, recyclable materials, which can adversely
impact the environment and the human health, if
not disposed of in an environmentally compatible
manner.
Delete personal data from waste equipment, if any.
European Conformity Mark
UK Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH 19