Christopeit Sport Omega Notice De Montage Et D'utilisation page 20

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check that all are there on the basis of the assembling steps. Please
note that a number of parts have been connected directly to the main
frame and preassembled. In addition, there are several other individual
parts that have been attached to separate units. This will make it easier
and quicker for you to assemble the equipment. Assembly time ap-
prox. 50min.
Step 1:
Attach the stabilizer (42+46) at mainframe (50).
1. Attach the front foot (46) with the preassembled transport rollers (47)
to the main frame (50). Do this with the two screws M8x90 (45), curved
washers (3), spring washers (28) and cap nuts (49). Attention: Mount the
front foot into right direction, so that the transport rollers don't touch
the floor during exercising.
2. Attach the rear foot (42) with height adjustable foot caps (43) to the main
frame (50). Do this with the two screws M8x90 (45), curved washers
(3), spring washers (28) and cap nuts (49). After assembly has been
completed, you can compensate for minor irregularities in the floor by
turning the top of the eccentric cap (43). The equipment should be set
up that the equipment does not move of its own accord during a training
session.
Step 2:
Attach the front post (10) at mainframe (50).
1. Push the handlebar support cover (51) onto the handlebar support (10).
2. Hold the handlebar support (10) with the computer cable (9) against the
main frame holder. Connect the plug for the computer cable (9) coming
out of the bottom of the handlebar support (10) with the matching plug
for the motor cable (95) coming out of the main frame (50). (Note: The
computer cable harness (9) projecting from the support (10) must not
slide into the tube, as it is required for later steps of installation.)
3. Place the handlebar support (10) in the locator provided for it in the main
frame (50). Ensure that the cable connections made are not squashed.
When putting the steering tube in place, push the former slowly down
into the locator in the main frame. Screw loosely the handlebar support
(10) onto the base frame (50) with the screws (2) and washers (3).
(Attention: This screw connection will screw final tightly in Step 3)
20