HQ Power VDP7525B Notice D'emploi page 5

• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• This device is designed for professional use on stage, in discos, theatres, etc. The VDP7525BL
can be used indoor (< 35°C, < 75%RH) with an alternating current of 230-240 VAC/50~60 Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong
their lives.
• Provide only 1 DMX input signal to each device, use only 1 DMX output. Do not mix 3 pins and 5
pins DMX cabling e.g. when the DMX controller is connected to the 3 pins input connector, the 3
pins output connector must also be used.
• Use the original packaging or the optional flight case (VDP7525BL/FC, not incl.) if the device is
to be transported.
• Keep this manual for future reference.
4. Features
• DMX-controlled via 4 modes
4-channel mode: basic control mode with dimmer, speed and 2 effect channels
9-channel mode: same as the 4-channel mode but with 5 extra zone channels
25-channel mode: each channel controls one lamp, ideal for pixel mapping
29-channel mode: first 4 channels for effect control and an additional 25 channels for separate
lamp control
• very powerful lighting via 25 x 75W PAR30 lamps (not incl.)
• fast locking system for quick and proper connection of several panels
• clear LED display on the backside for DMX addressing and easy follow-up of effects via small LED
matrix
• optional flight case for 5 blinders (not incl.): VDP7525BL/FC
5. Overview
Refer to the illustrations on page 2 of this manual.
VDP7525BL
1 mounting bracket/stand
2 bracket nuts
3 interlocking mechanism
4 power input
5 resettable fuse
6. Getting started
Choosing a Mounting Location
The VDP7525BL has been designed for indoor environments at temperatures up to 35°C.
For proper operation, the unit must be operated with an unobstructed air convection to its
metal housing.
Do not:
• Operate the projector in environments with an ambient temperature higher than 35°C and a
relative humidity higher than 75%.
• Operate the projector in a closed environment smaller than 10 m³ unless forced air convection is
provided.
Secure Mounting
Risk of injury. Overhead mounting requires extensive experience: calculating workload
limits, determining the installation material to be used... Have the material and the device
itself checked regularly. Do not attempt to install the device yourself if you lack these
qualifications as improper installation may result in injuries.
12/05/2010
VDP7525BL
6 control panel
7 DMX in- and outputs
8 LCD
9 MODE selection button
10 UP button
11 DOWN button
5
©Velleman nv