Eco-Aire 2400 Manuel D'utilisation page 9

Installing the filler panels
• Begin by assembling the left and right side filler panels together.
Slide part A into part B; Notice the range of adjustment. If the
openings on each side of the heater exceeds this range, you will
have to fill the gap by other means necessary to keep the window/
opening weather tight. Otherwise, proceed.
• Place the panel assembly against the bottom of the window sash
and bottom of the window frame. Slide apart the two sections
until the flange on part A meets the inside of the window frame
and the flange on part B meets the side of the heater. Using a drill
with a 5/16" socket bit, drive the self-tapping screw through the
hole in part A into part B. This sets the width of the panels.
• Peel away the protective coating from the two-sided tape on the
flanges and adhere it to the window and framing.
• Measure the filler panel width and cut the foam insulation to size.
Peel away the coating on the tape strips and apply the foam to
the panels.
• Finish the install by sealing around the outside of the heater and
filler panels with a weatherproofing silicone sealant.
Ussc
All manuals and user guides at all-guides.com
Window Installation
WINDOW Sill MOUNT-
ING BRACKETS
TWO-SIDED TAPE
A
B
SCREW
TWO-SIDED TAPE
CUT-TO-FIT
9