Publicité
Les langues disponibles
Les langues disponibles
The following instructions should be read by a qualified
technician to ensure that the appliance is installed, regu-
lated and technically serviced correctly in compliance with
current regulations.
Important: The power supply to the appliance must be
cut off before any adjustments or maintenance work is
done on it.
Positioning
The cooker is manufactured with type X degree protection
against overheating.
Levelling Your Appliance (only on certain models)
4 support feet which are adjusted using screws are lo-
cated in the lower part of the cooker. These level off the
oven when necessary. It is essential that the cooker be
standing level.
Mounting the legs (only on certain models)
Press-fit legs are supplied which fit under the base of
your cooker.
The appliance must not be installed behind
a decorative door in order to avoid overheating
Fitting on a Power Supply Cable
Opening the terminal board:
•
Using a screwdriver, prise on the side tabs of the ter-
minal board cover;
•
Pull open the cover of the terminal board.
To install the cable, proceed as follows:
•
unscrew the wire clamp screw and the contact screws
Note: the jumpers are factory-set for a single-phase
230V connection (Fig. A).
All manuals and user guides at all-guides.com
Installation Instructions
•
•
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load
indicated on the data plate. When connecting the cable
directly to the mains, install an omnipolar circuit-breaker
with a minimum contact opening of 3 mm between the
appliance and the mains. The omnipolar circuit breaker
should be sized according to the load and should comply
with current regulations (the green-yellow earth wire should
not be interrupted by the circuit breaker). The supply
cable should be positioned so that it does not reach a
temperature of more than 50°C with respect to the room
temperature, anywhere along its length.
Before making the connection, check that:
•
5
to make the electrical connections illustrated in fig. C
and fig. D, use the two jumpers housed in the box (fig.
B - reference "P")
fasten the supply cable in place with the clamp and
close the cover of the terminal board.
220-240V ~
H05RR-F 3x4 CEI-UNEL 35363
H05VV-F 3x4 CEI-UNEL 35746
N
L
Fig. A
N
L3
Fig. B
V 2N~
380-415
380-415
H05RR-F 4x4 CEI-UNEL 35363
H05VV-F 4x4 CEI-UNEL 35746
N
L2 L1
Fig. C
380-415
380-415
H05RR-F 5x2.5 CEI-UNEL 35363
H05VV-F 5x2.5 CEI-UNEL 35746
N
L3
Fig. D
the limiter valve and the home system can support the
P
L2
L1
V 3N~
L2
L1
Publicité
