Publicité
Les langues disponibles
Les langues disponibles
Cleaning
External cleaning
•
Clean the machine daily by rinsing it with clean water
after the work is finished.
Cooling air intake
•
Clean the cooling air intake when needed.
NOTICE! A dirty or blocked air intake results in the
machine overheating which causes damage to the
piston and cylinder.
Spark plug
•
If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
•
Ensure that the spark plug cap and ignition lead are
undamaged to avoid the risk of electric shock.
•
If the spark plug is dirty, clean it and at the same time
check that the electrode gap is 0.5 mm. Replace if
necessary.
NOTICE! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the
piston/cylinder.
These factors cause deposits on the spark plug
electrodes, which may result in operating problems and
starting difficulties.
•
An incorrect fuel mixture (too much or incorrect type
of oil).
•
A dirty air filter.
Functional inspection
General inspection
•
Check that nuts and screws are tight.
24 – English
MAINTENANCE
Bar
Check regularly:
•
Whether there are burrs on the edges of the bar.
Remove these with a file if necessary.
•
Whether the groove in the bar has become badly
worn. Replace the bar if necessary.
•
Whether the tip of the bar is uneven or badly worn. If
a hollow forms on the underside of the bar tip this is
due to running with a slack chain.
•
To prolong the life of the bar you should turn it over
when changing the diamond chain.
Carburetor
The carburettor is equipped with fixed needles to ensure
the machine always receives the correct mixture of fuel
and air. When the engine lacks power or accelerates
poorly, do the following:
•
Check the air filter and replace if necessary. When this
does not help, contact an authorised service
workshop.
Adjusting the idle speed
!
Start the engine and check the idling setting. When the
carburetor is set correctly the diamond chain should be
still while engine is idling.
CAUTION! Contact your dealer/service
workshop, if the idle setting cannot be
adjusted so that the diamond chain is
stationary. Do not use the machine until
it has been properly adjusted or repaired.
Publicité
