Publicité
Fig. 11
11.
Roll out one Slat Assembly (C) and position it on to the bottom edge of the Side Rails as shown
in Figure 11. Center Slat Assembly (C) and anchor one end with 4x35mm Flat Head Screws (P).
Pull the opposite end slat towards the opposite headboard so that the webbing in between the
slats is drawn taut. Secure that end slat to the rails with two 4x35mm Flat Head Screws (P).
Secure the remaining slats to the side rails with 4x35mm Flat Head Screws (P). See Figure 11.
K
A
12. Do not glue the dowels in this step.
With a rubber mallet, tap four 22x100mm Wood Dowels (K) into the holes at the top of each
Lower Headboard (A) as shown in Figure 12.
4663AFDH– Page 9 – 02/09
All manuals and user guides at all-guides.com
P
C
Fig. 12
P
K
K
A
x 28
x 4
Publicité
