Télécharger Imprimer la page

Whittier Wood Furniture 496Wa Instructions D'assemblage

Large huche classique

Publicité

Liens rapides

Model #
496Wa
48" x 48" Wide
Classic Hutch
Assembly Instructions
Congratulations!
This fine piece of furniture will make a gorgeous addition to
your home. For the best results, read the Assembly
Instructions and Finishing Hints before you begin your
project.
Service Policy: We will replace any part that is defective,
missing or damaged during assembly. For a replacement
part, directly contact Whittier Wood Products customer
service department by phone, fax, mail or email.
Hours: Our friendly customer service staff can be reached
Monday-Friday 7:00 a.m. to 5:00 p.m. (Pacific Time). You
may leave a message 24 hours a day, seven days a week.
800-653-3336 • Outside the U.S. or Canada: 541-687-0213 • Fax: 541-687-2060
CALL US FIRST! Do not return this item to the store
www.whittierwood.com • P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
P.O. Box 2827
Eugene, OR 97402 USA
IMPORTANT NOTES:
• For normal household use only. Not recommended for commercial use.
• Do not climb, sit or stand on this piece of furniture.
• Do not overload the shelves.
• Unload items before you move this unit.
• Before you load or move this unit, tighten all screws and supports.
• For maximum stability, attach unit to the wall using the enclosed
hardware as per instructions and supports.
• Before you begin your project, completely read the Assembly
Instructions and Finishing Hints.
• Store this item: 1- in its box; 2- in a dry place; 3- in temperatures that
range from 40°F to 90°F (not on a cold and possibly damp cement
floor).
• Periodically inspect your furniture for any loose glue joints, screws or
any other problem that might affect the stability of your furniture.
Tighten or repair as needed.
This assembly requires two people.
Serious or fatal crushing injuries can occur from furniture tip-over. Use of
tip-over restraints may only reduce but not eliminate the risk of tip-over.
To help prevent tip-over:
Place heaviest items in the bottom drawers.
Unless specifically designed to accommodate, do not set TVs or other
heavy objects on top of this product.
Never allow children to climb or hang on drawers, doors or shelves.
Never open more than one drawer at a time.
Warning: At least one tipping restraint kit was included with your piece of
Whittier Wood Furniture. When you receive your furniture, be sure to find
and properly install the tipping restraint(s). If you cannot locate the
restraint(s), please contact us immediately for replacement.
Notice to California Customers
California Prop 65 requires consumer goods to be labeled if any one of
850+ different chemicals or substances, including wood dust, is present
even in trace amounts. Drilling, sawing, sanding or machining wood
products generates wood dust, a substance known to the State of
California to cause cancer. Warning: This product contains a chemical
or substance known to the State of California to cause cancer, birth
defects or other reproductive harm. California Health and Safety Code
Section 25249.6
DESIGN SUBJECT TO CHANGE WITHOUT NOTICE.
To Order: Provide the furniture model number (upper
portion of this page), the part letter, production code,
quantity needed, reason for replacement and your full
name, address and telephone number.
Parts ship from our Eugene, Oregon factory within one or
two business days from the time we receive your request.
Please allow five to ten business days for delivery.
Production Code:
WARNING
08/13

Publicité

loading

Sommaire des Matières pour Whittier Wood Furniture 496Wa

  • Page 1 Never open more than one drawer at a time. Warning: At least one tipping restraint kit was included with your piece of Whittier Wood Furniture. When you receive your furniture, be sure to find and properly install the tipping restraint(s). If you cannot locate the restraint(s), please contact us immediately for replacement.
  • Page 2 496Wa Wide Classic Hutch – Parts List Please identify the parts and check that quantities received match those on this list. If you need to replace a part, refer to the following letter and model number. Part Description Quantity Left Side Panel...
  • Page 3 Refer to 495W Wide Classic Console Base instructions on how to test for your desired color. Fig. 1 1. To help you identifiy pieces and assemble this piece of furniture, lay out the parts in their approximate locations as shown in Figure 1. Page 3 — 496Wa — 08/13...
  • Page 4 2. Tap in Rafix Cams (K) with notch facing the edge: • 6 in the Center Shelf (Ea) Fig. 3 3. Screw Rafix Bolts (L) • 3 in the Left Side Panel (Aa) • 3 in the Right Side Panel (Ba) Page 4 — 496Wa — 08/13...
  • Page 5 5. Attach the Left Side Panel (Aa) to the Center Shelf (Ea) by sliding the Rafix Bolts (L) into the Rafix Cams (K). Tighten the cams. Repeat and attach Right Side Panel (Ba) to the center shelf. See Figure 5. Page 5 — 496Wa — 08/13...
  • Page 6 Left Side Panel (Aa) and the Right Side Panel (Ba). See Figure 7. Start all screws BEFORE YOU FULLY TIGHTEN EACH SCREW. Page 6 — 496Wa — 08/13...
  • Page 7 Add six #6 x 5/8" Philtruss Screws (N) with six Washers (O) between the upper and lower back. Align the screws with those at the top and bottom of the unit. See Figure 9. Page 7 — 496Wa — 08/13...
  • Page 8 Front Crown Moulding (H). Starting from the back, attach the Left Crown Moulding using three #8 x 1⅝" Black Screws (M) through the predrilled holes in the crown. See Figure 11. Repeat above steps to attach the Right Crown Moulding (J). Page 8 — 496Wa — 08/13...
  • Page 9 Top Shelf (Da) of the hutch with a #8 x 5/8" Pan Head Screw (P). See Figure 13. If a stud in the wall cannot be located, purchase the proper wall attachment hardware for your type of wall and secure the unit. Page 9 — 496Wa — 08/13...
  • Page 10 Nunca abra más de un cajón a la vez. Advertencia: Se incluyó al menos un juego de dispositivos anti-caídas con su pieza de Whittier Wood Furniture. Cuando reciba su mueble, asegúrese de buscar e instalar correctamente los dispositivos anti- caídas. Si no puede encontrar los dispositivos, comuníquese con nosotros de inmediato por un reemplazo.
  • Page 11 Primero comience sin apretar todos los tornillos Rafix en la parte superior del modelo 495W y en el divisor vertical y luego apriételos todos. retírela ahora del mueble. PAGE 2 SP — 496Wa — 08/13...
  • Page 12 (H) sobre el borde frontal del estante superior, céntrela respecto a los lados y fíjela utilizando cinco tornillos negros #8 x 1⅝" (M) a través de los orificios pre-taladrados en la moldura. Vea la Figura 10. PAGE 3 SP — 496Wa — 08/13...
  • Page 13 Ne jamais ouvrir plus d’un tiroir à la fois. Mise en Garde : Au moins un système anti-basculement a été livré avec votre meuble Whittier Wood Furniture. À la réception de votre meuble, assurez-vous de trouver et d’installer correctement ces systèmes. Si vous ne les trouvez pas, veuillez nous joindre immédiatement pour...
  • Page 14 Voir la Figure rondelles, ainsi que les neuf 4. Introduisez toutes les vis AVANT DE LES boulons rafix du dessus de la 495W, et retirez SERRER COMPLÈTEMENT. maintenant du meuble. PAGE 2 FR — 496Wa — 08/13...
  • Page 15 à égale distance des côtés et fixez-la au moyen de cinq vis noires no. 8 x 1⅝ po (M) que vous introduisez dans les trous préforés ménagés dans la couronne. Voir la Figure 10. PAGE 3 FR — 496Wa — 08/13...
  • Page 19 Whittier Finishing Hints instructions call for a slow drying epoxy glue. Carefully Checklist of materials read the label and instructions of the glue manufacturer. □ □ □ Rubber gloves Tack cloth #220 & #320 Your unit may not need glue. □...
  • Page 20 Whittier Finishing Hints Preparing the surface with a lint-free rag or tack cloth between coats. Sand each piece with #220 grit sandpaper. Sand with Some finishes tend to slightly raise the grain. This can the grain of the wood on flat surfaces and opposite the be easily controlled with a light sanding between coats.
  • Page 21 Consejos de Whittier para terminaciones Consejos de pegado Lista de control de materiales Estos son algunos consejos generales. Consulte las □ □ □ Guantes de Paño de Papel de lija instrucciones de ensamblaje para obtener información detallada hule adherencia No. 220 y No. sobre cómo pegar el producto específico que utilice.
  • Page 22 Consejos de Whittier para terminaciones Consejos para las terminaciones Aplicación de la capa de acabado Utilice productos de la misma marca para garantizar la Siempre debe leer y seguir las instrucciones de la etiqueta. compatibilidad. No se recomienda mezclar terminaciones a Mezcle suavemente el preparado para la capa de acabado, base de solventes y a base de agua.
  • Page 23 Conseils de finition de Whittier Conseils en matière de collage Liste de vérification des matériaux Cette section contient des conseils d'ordre général. Veuillez vous □ □ □ Gants en Chiffon résiné Papier de reporter aux instructions d'assemblage pour des renseignements □...
  • Page 24 Conseils de finition de Whittier enduits de finition à base de solvant et d'eau. Lisez et suivez Lisez et suivez les instructions figurant sur l'étiquette. toujours les instructions figurant sur le produit. Mélangez doucement l'enduit de finition; n'agitez pas. Le fait d'agiter peut entraîner la formation de bulles qui seront par la L'aulne est un bois dur et poreux dont l'aspect est souvent suite difficiles à...